General maintenance and repair (all types)
205
9
Replacement of spreader vanes:
Figure 9.8: Loosen the screws on the spreader vane
1. Loosen the self-locking nuts at the spreader vane and take them off the
spreader vane.
2. Install the new spreader vane onto the spreading disc. Make sure that you
have the correct spreader vane type.
Figure 9.9: Use new self-locking nuts
3. Screw-on the spreader vane (tightening torque: 20 Nm). For this purpose, al-
ways use new self-locking nuts.
To Next Page
Loading...
