General commissioning (all machine types)
57
8
9. Shorten the universal drive shaft, if required.
10. Preset the mounting height according to the fertiliser chart. See
8.6.2:
Settings as per fertiliser chart, page 64.
n CAUTION
Material damages due to excessively long drive shaft
When the machine is lifted up, the universal drive shaft halves can
come into contact inside each other. This can cause damage to the
drive shaft, the transmission or the machine.
Check the clearance between the machine and the tractor.
Make sure there is enough space (at least 20 to 30mm)
between the outer pipe of the drive shaft and the protective
cone on the spreader side.
NOTICE
Only your dealer or your specialist workshop may shorten the universal drive
shaft.
NOTICE
Observe the installation and shortening instructions provided in the operator’s
manual of the drive shaft manufacturer when checking and adjusting the
drive shaft. The operator’s manual is attached to the drive shaft on delivery.
To Next Page
Loading...
