Rauch MDS 8.2 - Page 4

4.2.1 Assembly overview 26
4.2.2 Agitator 29
4.3 Technical data 30
4.3.1 Versions 30
4.3.2 Technical data for the basic equipment 31
4.3.3 Technical data for the extensions 32
4.4 Special equipment 33
4.4.1 Extensions 33
4.4.2 Hopper cover 33
4.4.3 Row spreading system 34
4.4.4 Row spreading system 34
4.4.5 TELIMAT boundary spreading unit 34
4.4.6 Spreading width limiter 35
4.4.7 Hydraulic remote control unit for spreading width limiter 35
4.4.8 Two-way unit 35
4.4.9 Tele-Space universal drive shaft 35
4.4.10 Auxiliary lighting 35
4.4.11 Agitator RWK 6K 36
4.4.12 Agitator RWK 7K 36
4.4.13 Agitator RWK 15 37
4.4.14 Practice test kit 37
4.4.15 Fertilizer identification system 37
5 Axle load calculation 38
6 Transport without tractor 41
6.1 General safety instructions 41
6.2 Loading and unloading, parking 41
7 Commissioning 42
7.1 Accepting the machine 42
7.2 Tractor requirements 42
7.3 Mounting the universal drive shaft on the machine 43
7.3.1 Installing the standard drive shaft 43
7.3.2 Mounting the transmission with radial pin clutch 46
7.4 Installing the machine at the tractor 49
7.4.1 Preconditions 49
7.4.2 Mounting 49
7.5 Pre-setting the mounting height 53
7.5.1 Safety 53
7.5.2 Maximum admissible mounting height 53
7.5.3 Set the mounting height based on the fertilizer chart 54
7.6 Connecting the metering slide actuators 57
7.6.1 Connecting the hydraulic slide actuator: 57
7.6.2 Connecting the electric slide actuators 60
7.6.3 Connecting the electronic slide actuators 60
7.7 Filling the machine 61
8 Calibration 63
Table of contents
4
5902916 MDS 8.2/14.2/18.2/20.2