Rauch MDS 8.2 - Page 5

8.1 Determining the output volume 63
8.2 Implementing the calibration test 66
9 Spreading operation 71
9.1 Safety 71
9.2 Instructions regarding the spreading operation 71
9.3 Setting the application rate 73
9.4 Setting the working width 75
9.5 Using the fertilizer chart 80
9.5.1 Information on the fertilizer chart 80
9.6 Spreading with section control 85
9.7 Spreading of narrow field strips 86
9.8 Spreading to one side 87
9.9 Settings for unlisted fertilizer types 88
9.9.1 Requirements and conditions 88
9.9.2 Executing one pass 89
9.9.3 Running three passages 90
9.9.4 Evaluating results 92
9.9.5 Correcting settings 92
9.10 Full or limited border spreading 94
9.10.1 Full border spreading from the first track 94
9.10.2 Setting the GSE spreading width limiter 94
9.10.3 Adjusting the TELIMAT full and limited border spreading unit 96
9.11 Spreading on the headland with TELIMAT T1 special equipment 99
9.12 RV 2M1 row spreading system for hops and fruit cultivation 102
9.12.1 Pre-configuration of the machine 102
9.12.2 Adjustment of the row spacing and spreading width 103
9.12.3 Setting the application rate 103
9.13 Discharging residual material 104
9.14 Parking and unhitching the machine 105
10 Faults and possible causes 107
11 Maintenance and service 111
11.1 Safety 111
11.2 Wear parts and screw connections 112
11.2.1 Checking wear parts 112
11.2.2 Checking the screw connections 113
11.2.3 Checking the screw connections of the weigh cells 113
11.3 Opening the protective grid in the hopper 114
11.4 Cleaning the machine 116
11.5 Metering slide adjustment 117
11.5.1 Adjustment 119
11.6 Checking the agitator for wear 124
11.7 Checking the spreading disc hub 124
11.8 Dismounting and mounting spreading discs 125
11.8.1 Dismounting the spreading discs 125
11.8.2 Mounting the spreading discs 126
11.9 Checking the spreading disc flat spring 126
Table of contents
MDS 8.2/14.2/18.2/20.2 5902916
5