Rauch MDS 8.2 - Page 44

u
Grease the transmission spigot. Place the
universal drive shaft on the transmission
spigot.
Fig. 12: Pushing the universal drive shaft onto the
transmission spigot
u
Tighten the hex cap screw and nut using a
size 17 wrench (max. 35 Nm).
Fig. 13: Connecting the universal drive shaft
u
Push the universal drive shaft guard with
hose clamp over the universal drive shaft
and attach it to the transmission neck.
u
Tighten the hose clamp.
Fig. 14: Mounting the universal drive shaft guard
7. Commissioning
44
5902916 MDS 8.2/14.2/18.2/20.2