Rauch MDS 8.2 - Page 56

Setting the mounting height during late fertilizing
ü
The machine is installed at the highest connecting point of the upper link at the tractor.
ü
The lower link of the tractor is installed at the upper coupling point of the lower link of the
machine.
u
Determine the mounting heights A and B (above crop height) from the fertilizer chart.
u
Compare the mounting heights A and B plus the crop height with the maximum admissible
mounting heights at the front (V) and rear (H).
Fig. 26: Mounting position and height during late fertilizing
u
If the lifting height of the tractor is insufficient for setting the required mounting height: use the
lower coupling point on the lower link of the machine.
The following applies:
• A + crop height ≤ V: max. 730
• B + crop height ≤ H: max. 830
7. Commissioning
56
5902916 MDS 8.2/14.2/18.2/20.2