Instructions for Use MPR1 DATALOGGER
Manufacturer: zwo-399EN
RAUMEDIC AG, Hermann-Staudinger-Strasse 2, 95233 Helmbrechts, Germany Rev. 9, 2020-10-16
Page 35 of 98
After data deletion, alarm limit selection is carried
out.
Specification of the site of measurement and the
possibility of zeroing, in case a pressure sensor is
Patient monitoring. The memory mode "No storing"
is displayed in the status line by the symbol
.
Even in memory mode “No storage“ trend display
for up to 8 hours is possible. Beyond this period,
older data are overwritten.
4.2.6 View last measurement
From firmware version 2.00.0053 the option now exists of viewing the trend data of the last measurement.
Prerequisite for this is that data have been saved and the device memory has not already been deleted.
Open Function menu. Using the arrow keys select
the function "View last measurement".
Confirm with OK. This function is only available if
data are stored on the device.
This document is for information only
To Next Page
Loading...