Instructions for Use MPR1 DATALOGGER
Manufacturer: zwo-399EN
RAUMEDIC AG, Hermann-Staudinger-Strasse 2, 95233 Helmbrechts, Germany Rev. 9, 2020-10-16
Page 85 of 98
9 Accessories
Use accessories only, which have been approved by RAUMEDIC. Use of non-approved parts may lead
to damage on the system or faulty measurements. Please refer to the following 2 tables for the order
designation of the approved accessories:
Accessory as defined in directive 93/42/EEC respectively 90/385/EEC
NEUROVENT with sleeve housing
Stand holder DATALOGGER (e.g. for infusion)
Cable DATALOGGER GE/MARQUETTE, length 2.00 m
Cable DATALOGGER Philips/HP, length 2.00 m
Cable DATALOGGER Siemens/Draeger Infinity, length 2.00 m
Cable DATALOGGER SpaceLabs, length 2.00 m
Cable DATALOGGER Nihon Kohden, length 2.00 m
Cable DATALOGGER Nihon Kohden 41xx, length 2.00 m
Transducer Cable DATALOGGER Smiths Medical, length 2.00 m
Transducer Cable DATALOGGER MEDEX MX960, length 2.00 m
Transducer Cable DATALOGGER EDWARDS TRUWAVE, length 2.00 m
Transducer Cable DATALOGGER Becton Dickinson, length 2.00 m
Transducer Cable DATALOGGER Combitrans, length 2.00 m
ICP Temp Cable, length 2.00 m
ICP Temp shunt with jack plug, length 0.70 m
Wide range adapter MPR1/2
Wide range adapter MPR1/2
Table 8: Accessory as defined in directive 93/42/EEC respectively 90/385/EEC
Accessory not as defined in directive 93/42/EEC respectively 90/385/EEC
USB cable RAUMEDIC
®
DATALOGGER
Table 9: Accessory not as defined in directive 93/42/EEC respectively 90/385/EEC
This document is for information only