RAUMEDIC MPR1 - 2.6 Information and warning symbols; 2.7 Abbreviations; 2.8 Code designations on the connection sockets of the MPR1; 2.9 Catheter location and signal designations

Instructions for Use MPR1 DATALOGGER
Manufacturer: zwo-399EN
RAUMEDIC AG, Hermann-Staudinger-Strasse 2, 95233 Helmbrechts, Germany Rev. 9, 2020-10-16
Page 4 of 98
5.2 Displays when operating on mains power ..................................................................................... 73
5.3 Battery operation ............................................................................................................................ 73
5.4 Displays when operating on battery ............................................................................................... 73
5.5 Influence of the storage conditions on the battery operation ......................................................... 73
5.6 Battery maintenance ...................................................................................................................... 74
5.7 Information on how to handle battery packs .................................................................................. 74
6 Troubleshooting .................................................................................................................................. 75
6.1 Special instructions for the telemetric measurement of ICP .......................................................... 75
6.2 Error – Zero calibration of pressure channel ................................................................................. 76
6.3 Internal error – pressure channel ................................................................................................... 76
6.4 Internal error – temperature ........................................................................................................... 76
6.5 Memory full .................................................................................................................................... 76
6.6 Residual operating time – battery pack ......................................................................................... 76
6.7 Pressure sensor has been removed .............................................................................................. 77
6.8 Temperature sensor has been removed........................................................................................ 77
6.9 ECG cable disconnected ............................................................................................................... 77
6.10 Grave error A ................................................................................................................................. 77
6.11 Grave error B ................................................................................................................................. 77
6.12 Internal error – analogue output .................................................................................................... 77
6.13 Defective fuses .............................................................................................................................. 78
6.14 Reaction to fault messages and indications .................................................................................. 78
7 Cleaning and maintenance ................................................................................................................. 82
7.1 Cleaning the MPR1 ........................................................................................................................ 82
7.2 Cleaning, disinfecting and sterilising the cables and sensors ....................................................... 82
7.2.1 Cleaning .................................................................................................................................. 82
7.2.2 Disinfection ............................................................................................................................. 82
7.2.3 Sterilisation ............................................................................................................................. 83
7.3 Cleaning the mains adaptor ........................................................................................................... 83
8 Inspections, Safety and Measurement Checks ................................................................................ 84
8.1 General .......................................................................................................................................... 84
8.2 Safety check (SC) .......................................................................................................................... 84
8.3 Measurement check (MC) ............................................................................................................. 84
9 Accessories ......................................................................................................................................... 85
10 Electromagnetic compatibility ........................................................................................................... 86
10.1 Manufacturer's declaration on the EMC requirements according to IEC 60601-1-2:2014 ............ 86
10.1.1 Accuracy under the influence of electromagnetic interference phenomena .......................... 86
10.1.2 General information ................................................................................................................ 86
10.1.3 Electromagnetic emissions ..................................................................................................... 87
10.1.4 Electromagnetic immunity ...................................................................................................... 87
10.2 Manufacturer's declaration on the EMC requirements according to IEC 60601-1-2:2007 ............ 88
10.3 Electromagnetic emissions ............................................................................................................ 89
10.4 Electromagnetic immunity .............................................................................................................. 90
11 Technical parameters (Specification) ................................................................................................ 93
11.1 Technical data ................................................................................................................................ 93
11.2 Environmental conditions ............................................................................................................... 95
11.2.1 Operating and storage temperature ....................................................................................... 95
11.2.2 Humidity .................................................................................................................................. 95
11.2.3 Atmospheric pressure ............................................................................................................. 95
12 Environment and disposal.................................................................................................................. 95
13 Liability and warranty .......................................................................................................................... 95
14 Index ..................................................................................................................................................... 96
15 Enclosures ........................................................................................................................................... 97
This document is for information only