Ravelli Hydro - Page 150

Use and maintenance manual Touch Radio Hydro
Pag.41
Rev.0 18/05/2021
EN
Phase Description
OFF The stove is o󰀨
WAIT FOR PELLETS
OUT OF
When the switch-on request from ECO-STOP mode coincides with an automatic
switch-o󰀨 condition (from the TIMER), the stove turns on ensuring total cleaning of
the brazier before switching to FINAL CLEANING.
AUGER OVERFLOW
CONDITION: when the pellet setting (set pellets +5) is near the continuous load
condition.
SOLUTION: Set the value back to 0.
GENERIC ALARM The stove is in alarm state; refer to the troubleshooting chapter.
ANOMALY (general)
The stove has detected an anomaly; refer to the troubleshooting chapter.
By pressing the conrmation key, the problem is described.
AUTOMATIC CLEAN-
ING SYSTEM ACTIVE
For models with automatic cleaning system it indicates the operating state of the
same.
STAND BY
Forced shutdown state when the boiler water reaches 85°C. The stove restarts au-
tomatically if the restart conditions are met.