CHAPTER 3
50 CAN Sidekick Pro Injection for Case IH 3/4XXX Installation and Operation Manual
FIGURE 73. Installed Hoses on Pump Station
7. Connect one end of the 3/4” hose to one of the remaining open elbow ports on the rise tee fitting.
8. Secure the hose to the fitting using two of the provided hose clamps.
9. Connect the hose to one of the open 3/4” hose barb ports on the bottom of the rear pump at the pump
station.
10. Secure the hose to the pump station with two hose clamps.
11. Repeat step 7 to step 10 for the remaining open 3/4” ports on the front pump of the pump station and rinse
tee.
FIGURE 74. Dual Pump Rinse Hose Installation 3XXX Machines
NOTE: On 4XXX machines, route the dual pump station rinse tee and hoses across the frame to the rinse
valve attached to the fill station.
Rinse Tank Drain
Valve
Dual Pump Station Rinse Tee Installed
Approximately 4’ from Pump Station
Dual Pump Station
Nylon Hose
Guard Sleeve
4XXX Machines: Route Dual Rinse Tee Across
Frame to Rinse Valve on Fill Station
To Next Page
Loading...
