5-14
hsb
2
Plus Series Fishfinders
Editing the
Waypoint Details
Use the soft keys, shown in the following illustration, to highlight the
required symbol, then press ENTER to confirm the selection.
Press ENTER or CLEAR to return to the default soft keys.
4. To edit the waypoint name, press the NAME soft key. The NAME WAYPOINT
window is displayed.
Using the trackpad to edit the name:
iv. Use the left or right side of the trackpad to move the cursor to the char-
acter you wish to change.
v. Then use the top or bottom of the trackpad to scroll through the charac-
ters.
Using the ST80 Navigator Keypad to edit the name:
i. Use the left or right arrows of the Navigator’s keypad to move the cur-
sor to the character you wish to change.
ii. Use the up and down arrow keys to scroll through the characters.
or
Use the alphanumeric keypad to change the character, as described in
Using the ST60 or ST80 Navigator Keypad on page 5-16
When you have finished editing the name, to remove the window, press
ENTER to save the name or CLEAR to cancel the operation. The waypoint
name replaces the waypoint number.
Press ENTER or CLEAR to return to the default soft keys.
5. To edit the waypoint position, press the EDIT WAYPOINT soft key, followed
by POSITION. The Waypoint Position pop-up is displayed.
Use the soft keys to select LAT, LON, BRG or RNG.
Using the trackpad to edit the value:
i. Use the left or right side of the trackpad to move the cursor to the char-
acter you wish to change.
ii. Use the top or bottom of the trackpad to scroll through the characters.
iii. Adjust each parameter until the waypoint position is correct.
Using the ST80 Navigator Keypad to edit the value:
i. Use the left or right arrows of the Navigator’s trackpad to move the cur-
sor to the character you wish to change.
ii. Use the up and down arrow keys to scroll through the characters.
SELECT SYMBOL
D4178-1
EDIT
WAYPOINT
To Next Page
Loading...
