Chapter 5: Standard Chart Operations 5-15
Erasing a Waypoint
or
Use the alphanumeric keypad to change the character. Press the def/2
key for East, mn/5 for North, rst/7 for South, and uvw/8 for West.
iii. Adjust each parameter until the waypoint position is correct.
When you have finished editing the position, press ENTER to save the position
or CLEAR to cancel the operation.
Press ENTER or CLEAR again, the Waypoint Position window is removed
from the screen and the default soft keys are displayed.
Erasing a Waypoint
You cannot erase the target waypoint or waypoints that are used in routes.
However, you can remove a waypoint from the current route - see Editing a
Route on page 5-28.
If you try to erase a waypoint that is used in a saved route you are warned
“WAYPOINT IS USED IN A ROUTE & CANNOT BE DELETED”
➤ To delete a waypoint using the cursor:
1. Move the cursor over the waypoint, until the letters WPT are displayed. The
waypoint soft keys are displayed.
2. Press the ERASE WAYPOINT soft key. The waypoint is removed from the
screen and the Waypoint List is updated.
Note: If you have stopped a GOTO (see Stop Follow or Stop Goto on
page 5-34), the target waypoint remains displayed as a target; you need to use
the
CLEAR GOTO
soft key before you can erase the waypoint using the cursor.
➤ To delete a waypoint using the waypoint list:
1. Select the waypoint from the waypoint list as previously described. The
waypoint list soft keys are displayed.
2. Press the EDIT WAYPOINT soft key, followed by ERASE WAYPOINT. The way-
point is removed from the screen and the waypoint list is updated.
Moving a Waypoint
You can move any waypoint except the target waypoint (the waypoint you are
following). You can use the Waypoint soft keys and cursor to move the
selected waypoint, or you can edit the waypoint position.
CAUTION:
Take care when editing waypoints as it is possible to move waypoints that are
used in routes stored in the Route Database. List.
WPT
ERASE
WAYPOINT
MARKS
WAYPOINT
LIST
To Next Page
Loading...
