Raymarine hsb2 PLUS - Saving the Current Route

5-22 hsb
2
Plus Series Fishfinders
Saving the Current
Route
6. To remove a waypoint from the New Route column, highlight the way-
point and press the REMOVE WAYPOINT soft key.
Note: The
INSERT WAYPOINT or REMOVE WAYPOINT action adds/removes the
highlighted waypoint to/from the Route column, regardless of which column
is selected.
7. When all waypoints have been entered, press the ACCEPT ROUTE soft key
(or ENTER) to complete the route.
Note: The completed route is stored in the display unit and will be re-dis-
played if you turn the unit off then on again. However, on an integrated system
it is possible for a current route from another unit to overwrite this route; it is
therefore recommended that you save the route, as described in Saving the
Current Route.
Saving the Current Route
You can save up to 20 named routes in the route database list. These routes can
then be re-displayed and followed at a later date. When you save the route, all
new waypoints are saved in the Waypoint List.
Note: If the current route has not been saved, when you attempt an operation
that affects this route, e.g., CLEAR ROUTE, you are prompted to save it.
➤ To save and name the current route:
1. To access the SAVE ROUTE soft key, press the ROUTE soft key, followed by
MORE.
2. Press the SAVE ROUTE soft key. The save route pop-up and the NAME ROUTE
soft keys are displayed as illustrated in Figure 5-6.
3. The next available entry on the route list is highlighted.
(If required, you can use the trackpad to select another position in the list;
this can be a blank slot, or an existing route that you no longer require).
REMOVE
WAYPOINT
ACCEPT
ROUTE
ROUTE
SAVE
ROUTE