Chapter 8: Maintenance and Problem Solving 8-3
Resetting the
System
8.2 Resetting the System
There are three types of reset available for the Fishfinder display:
• Factory Reset: This resets all values back to their original factory settings.
CAUTION:
The factory reset clears the Marks database, the chartplotter Waypoints
and Routes databases, the sonar depth offset, and speed and temperature
calibrations. The factory reset also returns the sonar repeater to its
master mode.
• Power-On Reset: When you turn the display off and on again, the screen
reverts to the fishfinder or chart picture with all windows cleared.
• Picture Reset: Press and hold the DISPLAY key for two seconds to return
the screen to the full-screen picture of the top window with all windows
cleared.
At power-on, the last-used values are retained for all the options, except for
those listed in the following table which are reset to the factory default each
time.
➤ To perform a factory reset:
1. Press MENU.
2. Press the SYSTEM SET UP soft key to display the System Set Up page (see
Section 7.3 for details).
3. Press and hold MENU for 5 seconds.
A countdown timer is displayed. If you release the MENU key before the
timer reaches zero, the reset is not performed.
When the reset request has been accepted, the system restarts.
The factory default settings are listed in Section 7.3.
Table 8-1: Power On Default Settings
Item Power-on setting
Heading Mode
Brightness
Mono LCD
Color LCD
North Up (chart)
ON at 100%
ON at 42% if previously left ON, or else
OFF if previously set to OFF.
To Next Page
Loading...
