14 RC400 GPS Chartplotter
Removing a Gold Chart Card
CAUTION:
Do not use a metallic instrument (such as a screwdriver or pliers) to
aid removal, as this can cause irreparable damage.
➤ To remove a Gold Chart card:
1. Loosen the two retaining screws on the rear of the unit.
2. Remove the battery tray as described above in Figure 2-2 .
3. Grip the card lip with a fingernail and pull to the side to remove it
from its slot.
4. Flip unit over so card drops out.
2.5 Bracket Mounting
The unit can be conveniently bracket-mounted on a dash area or
deckhead. Mount the unit as shown in Figure 2-5 :
1. Using the mounting base as a template (or using the template at the
end of this handbook), mark the locations of the screw holes on the
mounting surface.
2. Drill the holes where marked.
3. Use the supplied hardware to fix the mounting base at the marked
locations.
4. Attach the mounting bracket to the mounting base as shown.
5. Attach the knob. Adjust the display angle and tighten the knob.
6. Slide the RC400 downward onto the mounting bracket until the tabs
at the bottom of the bracket enter the corresponding indentations on
the chartplotter.
7. Firmly press the RC400 onto the bracket until it clicks into place.
To Next Page
Loading...
