36 RC400 GPS Chartplotter
Screen Saver
This function defines the timeout period after which the LCD is switched
off following keypad inactivity.
Either OFF (when this function is disabled) or the timeout value (either in
minutes or in seconds) is shown.
Move the trackpad horizontally to adjust the value of the timeout. The
sequence of the values is as follows:
• OFF
• from 5 seconds to 1 minute, in steps of 5 seconds
• from 1 minute to 59 minutes, in steps of 1 minute
For example, a setting of 5 MIN switches off the LCD after the keypad has
not been pressed for 5 minutes.
The LCD is switched on again following the next key press. The selected
value is retained on power down. The default is OFF.
Light Saver
This function defines the timeout period after which the backlight is
switched off following keypad inactivity.
Either OFF (when this function is disabled) or the timeout value (either in
minutes or in seconds) is shown.
Move the trackpad horizontally to adjust the value of the timeout. The
sequence of the values is as follows:
• OFF
• from 5 seconds to 1 minute, in steps of 5 seconds
• from 1 minute to 59 minutes, in steps of 1 minute
For example, a setting of 5 MIN switches off the backlight after the
keypad has not been pressed for 5 minutes.
The backlight is switched on again following the next key press. The
selected value is retained on power down. The default is OFF.
To Next Page
Loading...
