Chapter 2: Installation 19
2.8 System Check and Initial Switch On
When installation is complete and all connections have been made, re-
check the installation before using the system for navigation. If problems
occur, refer to Chapter 6:Maintenance & Troubleshooting.
Initial Switch On
To switch on the chartplotter, press the POWER key.
If necessary, adjust the lighting and contrast (see Chapter 4).
If desired, change the default language settings as follows:
1. Press the PAGE key to display the setup function bar.
2. Using trackpad left/right, select the SYSTEM SET UP function and press
ENTER. The SYSTEM SET UP menu is displayed, listing the parameters
and their current settings:
Figure 2-7: System Set Up Menu
3. Using trackpad up/down, select the LANGUAGE option.
4. Using trackpad left/right, select the desired language.
5. Press ENTER to return to the setup functions. The chartplotter now
uses the selected language.
6. Press CLEAR to return to the normal chart screen.
SYSTEM SET UP
DISTANCE UNITS
DEPTH UNITS
VARIATION
NM
METRES
_.__
BEARING MODE
TRUE
D6531-1
SPEED UNITS KNOTS
DATE FORMAT
TIME OFFSET
SIMULATOR
SIMULATED SOG
DD/MM/YY
UTC
OFF
____
VARIATION MODE AUTO
LANGUAGE
ENGLISH
SCREEN SAVER
LIGHT SAVER
OFF
OFF
SIMULATED COG ____
To Next Page
Loading...
