24 RC400 GPS Chartplotter
2. Press trackpad left/right to highlight SYSTEM SET UP and press ENTER
to display the System Set Up menu.
3. Use trackpad up/down to highlight the SIMULATOR option.
4. Use trackpad left/right to select ON.
5. If necessary, use trackpad up/down to highlight, in turn, the SIMU-
LATED SOG and COG options and trackpad left/right to set as desired.
Speed is set in 1Kt intervals and Course in 1° intervals.
6. Press CLEAR twice to return to the chart screen.
7. A flashing SIM indicator appears at the top left of the chart screen.
3.4 Controlling the Display
This section describes how to:
• Change the display mode
• Move around the chart by panning the display, changing the chart
center and changing the chart scale
Selecting the Display Mode
Use the PAGE key to select the display mode. Select the following modes
by repeat presses of the PAGE key as listed below and as shown overleaf:
• Set Up functions (see Chapter 4)
• Course Deviation Indicator (CDI)
• Bearing & Distance Indication (BDI)
• Waypoint data
• Navigation data
• Time/Date data
• Return to Chart Display
Note: The setup function bar is displayed when first entering a screen,
press CLEAR to hide this bar.
Note: Press GOTO to return to normal Chart display at any time
To Next Page
Loading...
