58 RC400 GPS Chartplotter
Saving the Current Route
You can save up to 20 named routes in the route database. These routes
can then be re-displayed and followed subsequently.
Note: If you attempt an operation that affects this route (CLEAR ROUTE,
for example) before the current route is saved, you are prompted to save
it.
➤ To save and name the current route:
1. Select ROUTES, followed by MORE.
2. Select SAVE ROUTE. The Save Route list is displayed.
3. The next available entry on the list is highlighted. You can use track-
pad up/down to select another position in the list, which can be a
blank slot or an existing route you no longer need.
4. Press ENTER to save the route.
Press ENTER again (in response to the prompt) to name the route or
CLEAR to save as the default ROUTE XX, where XX is the next avail-
able number.
When naming a route, use the trackpad to move the cursor right or left to
the character to be edited. Use trackpad up/down to scroll through the
characters. The name can contain up to eight alphanumeric characters,
including spaces.
5. Press ENTER to finish and clear the Route List, then press CLEAR
twice to return to the chart mode.
D4680-1
To Next Page
Loading...
