32 RC400 GPS Chartplotter
2. Use trackpad left/right to highlight SYSTEM SET UP and press ENTER
to display the System Set Up menu:
Figure 4-1: System Set Up Menu
3. Use trackpad up/down to move the highlight up or down the list.
4. When the desired parameter is highlighted, use trackpad left/right to
step through the settings.
5. When the desired values have been chosen, press ENTER to imple-
ment the change and return to the set up function bar.
Note: Settings are not saved until the ENTER key is pressed.
6. Press CLEAR to clear the function bar and return to normal operation.
Note: To return all settings to their original factory settings, perform a
factory reset as described in Chapter 6.
The table below lists the System menus and their options, shows the
factory default settings and provides space to make a note of personal
settings. Each parameter is described in the following subsections.
SYSTEM SET UP
DISTANCE UNITS
DEPTH UNITS
VARIATION
NM
METRES
_.__
BEARING MODE
TRUE
D6531-1
SPEED UNITS KNOTS
DATE FORMAT
TIME OFFSET
SIMULATOR
SIMULATED SOG
DD/MM/YY
UTC
OFF
____
VARIATION MODE AUTO
LANGUAGE
ENGLISH
SCREEN SAVER
LIGHT SAVER
OFF
OFF
SIMULATED COG ____
To Next Page
Loading...
