Managing Hardware with CLI Commands
5-14 SmartEdge 100 Router Hardware Guide
Memory Memory for which this circuit board is entitled:
• Max—All memory on the circuit board is enabled.
• nnnn MB—Size in MB of enabled memory.
Mfg Date dd/mm/yyyy—Date unit was manufactured.
MIC n For each MIC slot n:
• MIC-type—For a list of MIC types, see Table 5-12.
• Not Present—MIC is not installed.
MinnowCPLD Ver Minnow CPLD revision; applicable to the circuit board only.
ODD Status Not Available
POD Status Status of the POD tests:
• Success—Unit passed all POD tests.
• Failure—Unit failed one or more POD tests.
Port n—Port number if hardware data is port specific.
Ports Entitled All—All physical ports are entitled.
AC Power Supply Status
DC Power Supply A Status
DC Power Supply B Status
Status for each power supply:
• No Power—Power has failed, is disconnected, or is not installed.
• Normal—Power is being supplied by this source.
Redback Approved State of transceiver testing for this SFP optical transceiver:
• No—Redback has not tested.
• Yes—Redback has tested.
RxPwrMin[dbm]
2
RxPwrMax[dbm]
–nn.nn—Receiver sensitivity (minimum) and overload level (maximum) for the version of the SFP
transceiver installed in this port.
Serial No nnnnnnnnnnnnnn—Unique identifier for this unit; 14 alphanumeric characters.
Serial Number nnnnnnnnnn—Unique identifier for this transceiver; 10 alphanumeric characters
SFP / Media Type Version and cable type for the SFP transceiver installed in this port.
• FX / MM—Short range transceiver, multimode fiber.
• LX / SM—Long range transceiver, single-mode fiber.
• LX10 / SM—Long range transceiver, single-mode fiber.
• SX / MM—Short range transceiver, multimode fiber.
SharkFpga Ver Shark FPGA revision; applicable to the circuit board only.
SlipFpga rev SLIP FPGA revision; applicable to the circuit board I/O carrier card functions only.
Slot • slot—Slot number for this unit.
• N/A—No slot number for this unit.
SquidFpga Ver Squid FPGA revision; applicable to the circuit board only.
STAT LED State of the STAT LED. Applicable only to the circuit board controller functions (slot 1):
• Green—POD tests have passed.
• Green blinking—System is initializing.
• Red—POD tests have failed since the last system initialization.
• Red blinking—System has found an error, and initialization is proceeding with best effort.
• Off—Power is off or not present.
Table 5-13 Output Fields for the show hardware Command with the detail Keyword (continued)
Field Description
To Next Page
Loading...