56
Description
Before a tool is checked for missing teeth or excessive runout, it is
first set for radius/diameter. The diameter Cutting edge check cycle
then moves the rotating tool into the beam until the teeth interfere
with the beam by the cutting edge runout tolerance value. This value
is defined by the R06=k input.
The spindle speed is calculated from the minimum pulse signal delay
RENC[15] of the NC1 system and the number of teeth on the cutting
tool. This ensures that when each tooth enters the beam, a
permanent beam cut signal is held unless a tooth is either missing or
is out of tolerance. The beam cut signal is monitored for a minimum of
two revolutions.
Format R02=2. or R02=3. R03=c [R06=k R13=m R17=q R18=r
R19=s R26=z R24=x R09=f]
L9862
where [ ] denotes optional inputs
Example R02=2. or R02=3. R03=6. R06=0.02 R13=1. R17=5.
R18=25. R19=2500 R26=6. R24=5. R09=0.1
L9862
Subroutine inputs
The following inputs are used with this subroutine:
R02=2. For details of these cycles, see either “Tool radius/
R02=3. diameter setting” on page 43 or “Tool length and radius
setting” on page 49.
R02=4. Cutting edge check without tool offset updating.
Cutting edge checking
To Next Page
Loading...
Need help?
General
