58
signal delay of the control and the number of teeth on
the tool.
Default value: 3150 rev/min.
R24=x x= Cylinder profile checking distance, i.e. the spindle axis
movement, while edge checking. The value is
incremental from the R26=z input radial measuring
position. It is used in conjunction with the R09=f input
feed rate.
Default value: Zero (0)
R26=z z= Measuring height of tool.
This is the Z-axis position from the end face of the tool
at which measurement takes place.
Default value: 5.0 mm (0.197 in)
Outputs
The following output is set or updated when this cycle is executed:
RENC[48] Out of tolerance / Missing edge flag.
This is set when either the tool cutting edge runout is
out of tolerance, provided the R06=k input is used, or
an edge is missing from the tool.
(2 = Out of tolerance / edge missing
0 = In tolerance / no edges missing)
Alarms
The following alarms may be generated when this cycle is executed.
ACTIVE BEAM CUT
Cutting edge checking
To Next Page
