69
T2
M6 Select the next tool and continue.
(continue machining)
If the broken tool flag method is used, the call cycle is modified as
shown:
L9800
R25=50.R26=100.R13=1. Make a broken tool check
L9864 without raising an alarm.
The RENC[48] flag is set.
IF RENC[48]==1 GOTOF LN100 Go to LN100
(continue program)
Block LN100 will contain corrective actions. For example, selecting a
sister tool for use, or select a new pallet/component.
Broken tool detection (radial check)
To Next Page
Loading...
