Using a Printer Server
18
1
Using NetWare
This section describes the setting procedure for network printers in the NetWare
environment. In the NetWare environment, you can connect the machine as a
“print server” or “remote printer”.
Important
❒ IPv6 cannot be used on this function.
❖ Setting procedure
• When using the machine as a print server
A Installing SmartDeviceMonitor for Admin.
B Setting the network interface board.
C Turning the machine off and then back on.
• When using the machine as a remote printer
A Installing SmartDeviceMonitor for Admin.
B Setting the network interface board.
C Setting NetWare.
D Starting the print server.
Note
❒ This procedure assumes an environment is already prepared for normal Net-
Ware running the printing service setting.
❒ The procedure is explained with the following example settings:
• File server’s name …CAREE
• Print server’s name …PSERV
•Printer’s name …R-PRN
• Queue name …R-QUEUE
❖ Using SmartDeviceMonitor for Admin
To use the machine in a NetWare environment, use SmartDeviceMonitor for
Admin to set the NetWare printing environment.
Note
❒ The NetWare Client provided by Novell is required to set the printing en-
vironment using SmartDeviceMonitor for Admin under the following en-
vironments:
• NDS mode in Windows 95/98/Me
• NDS or Bindery mode in Windows 2000/XP, Windows NT 4.0
Reference
p.37 “Installing SmartDeviceMonitor for Admin”
To Next Page
Loading...
