Monitoring and Configuring the Printer
72
2
❖ Setting login mode for file server
msh> netware login server
❖ Setting login mode for NDS tree
msh> netware login tree
❖ Setting login mode for NDS tree name
msh> netware tree “NDS name”
❖ File transfer protocol
msh> netware trans {ipv4pri|ipxpri|ipv4|ipx}
• If you do not specify the protocol, the current setting is displayed.
passwd
Use the “passwd” command to change the remote maintenance password.
❖ Changing the Password
msh> passwd
• Enter the current password.
• Enter the new password.
• Renter the new password to confirm it.
❖ Changing the Password of the administrators using the Supervisor
msh> passwd {Administrator ID}
• Enter the new password.
• Renter the new password to confirm it.
Note
❒ Be sure not to forget or lose the password.
❒ The password can be entered using up to 32 alphanumeric characters. Pass-
words are case-sensitive. For example, "R" is not the same as "r".
Protocol Set Protocol
ipv4pri IPv4+IPX(IPv4)
ipxpri IPv4+IPX(IPX)
ipv4 IPv4
ipx IPX
To Next Page
Loading...
