Monitoring and Configuring the Printer
44
2
Configuring the Energy Saver Mode
Follow the procedure below to configure Energy Saver mode.
A Start SmartDeviceMonitor for Admin.
B On the [Group] menu, point to [Search Device], and then click [IPv4], [IPX/SPX]
or [IPv4 SNMPv3].
A list of machines using the selected protocol appears.
Select the protocol of the machine whose configuration you want to change.
If you are using IPv4 SNMPv3, enter the user authentication.
C Select the machine whose settings you want to make.
To make settings for all machines in the selected group, select no machine.
D On the [Group] menu, point to [Energy Save Mode], point to [Set Individually] to
make the settings for only the selected machine or point to [Set By Group] to
make the settings for all machines in the selected group, and then click [On],
[Off], or [Timer Settings ...].
E Quit SmartDeviceMonitor for Admin.
Note
❒ For details about the setting for Energy Saver mode, see SmartDeviceMon-
itor for Admin Help.
Setting a Password
Follow the procedure below to set a password.
A Start SmartDeviceMonitor for Admin.
B On the [Group] menu, point to [Search Device], and then click [IPv4], [IPX/SPX]
or [IPv4 SNMPv3].
A list of machines using the selected protocol appears.
Select the protocol of the machine whose configuration you want to change.
If you are using IPv4 SNMPv3, enter the user authentication.
C In the list, select a machine whose configuration you want to change.
D On the [Tools] menu, click [NIB Setup Tool].
NIB Setup Tool starts when the network interface board is default.
E Click [Web browser], and then click [OK].
A Web browser opens and the window for entering the login user name and
password for the Web Image Monitor administrator appears.
To Next Page
Loading...
