Monitoring and Configuring the Printer
70
2
ipp
Use the “ipp” command to view and configure IPP settings.
❖ Viewing settings
The following command displays the current IPP settings:
msh> ipp
❖ IPP timeout configuration
Specify how many seconds the computer waits before canceling an interrupt-
ed print job. The time can be entered between 30 to 65535 seconds.
msh> ipp timeout [30 - 65535]
❖ IPP user authorization configuration
Use IPP user authorization to restrict users to print with IPP. The default is
“off”.
msh> ipp auth {basic|digest|off}
• User authorization settings are “basic” and “digest”.
• If user authorization is specified, register a user name. You can register up
to 10 users.
❖ IPP user configuration
Configure IPP users according to the following messages:
msh> ipp user
The following message appears:
msh> Input user number (1 to 10):
Enter the number, user name, and password.
msh> IPP user name:user1
msh> IPP password:*******
After configuring the settings, the following message appears:
User configuration changed.
ipv6
Use the “ipv6” command to display and configure IPv6 settings.
❖ View Setting
msh> ipv6
❖ IPv6 stateless address
msh> ipv6 stateless {on|off}
To Next Page
Loading...
