Monitoring and Configuring the Printer
68
2
hostname
Use the “hostname” command to change the printer name.
❖ View settings
msh> hostname
❖ IPv4 Configuration
msh> hostname “interface_name ” “printer_name”
• Enter the printer name using up to 63 alphanumeric characters.
• You cannot use a printer name beginning “RNP” (in either upper or lower
case).
• The Ethernet interface and IEEE 802.11b interface will have the same print-
er name.
• wlan can be specified only when the IEEE 802.11b interface is installed.
❖ Initializing the printer name for each interface
msh>hostname “interface_name” clear name
ifconfig
Use the "ifconfig" command to view and configure TCP/IP (IP address, subnet
mask, broadcast address, default gateway address) for the printer.
❖ View settings
msh> ifconfig
❖ IPv4 Configuration
msh> ifconfig “interface_name” “parameter” “address”
• If you did not enter an interface name, it is automatically set to the Ethernet
interface.
• wlan can be specified only when the IEEE 802.11b interface is installed.
The following explains how to configure an IPv4 address 192.168.15.16 on
Ethernet interface.
msh> ifconfig ether 192.168.15.16
Interface name Interface configured
ether Ethernet interface
wlan IEEE 802.11b interface
Interface name Interface configured
ether Ethernet Interface
wlan IEEE 802.11b Interface
To Next Page
Loading...
