Using SmartDeviceMonitor for Admin
37
2
• Checks the machine's network settings and detailed device information.
• Enables you to change the machine's network settings.
• You can check details of print jobs sent from a computer.
• Allows you to check job histories of printed, faxed (LAN-Fax), scanned,
and photocopied documents identified by user codes.
•
Allows selection of functions such as printing and scanning for each user code.
• Fax numbers and e-mail addresses stored in the machine can be changed
and saved by computer.
• You can check each fax job history entry.
• You can make settings for and display the status changes of group devices.
• Using Address Management Tool, you can manage LAN-Fax numbers,
user names for Scan to Folder, and addresses for sending and receiving In-
ternet faxes.
• The e-mail sender’s name and folder can be protected.
Installing SmartDeviceMonitor for Admin
Follow the procedure below to install SmartDeviceMonitor for Admin
A Quit all applications currently running.
B Insert the CD-ROM into the CD-ROM drive.
The installer starts.
C Select an interface language, and then click [OK].
The default interface language is English.
D Click [SmartDeviceMonitor for Admin].
E Click [Next >].
The software license agreement appears in the [License Agreement] dialog box.
F After reading through its contents, click [Yes].
G Follow the instructions on the screen.
A message appears when the installation is completed.
H Click [OK].
A message about restarting the computer may appear. Restart the computer
to complete installation.
Note
❒ Auto Run may not work under certain operating system settings. In this
case, launch “SETUP.EXE” located on the CD-ROM root directory.
❒ If you are required to restart the computer after installing SmartDevice-
Monitor for Admin, restart the computer and continue the configuration.
To Next Page
Loading...
