Registering Folders
235
7
Note
❒ To register the name, see Registering Names”.
❒ You can enter up to 64 characters for the user name.
❒ You can enter up to 64 characters for the password.
❒ You can enter a path using up to 128 characters.
❒ To specify a folder, you can either enter the path manually or locate the
folder by browsing the network.
❒ If the connection test fails, check the settings, and then try again.
❒ When [Do not Specify] is selected, the SMB User Name and SMB Password
that you have specified in Default User Name / Password (Send) of File
Transfer settings applies.
❒ If User Authentication is specified, contact your administrator.
Reference
p.204 “Registering Names”
p.235 “To locate the folder manually”
p.236 “To locate the folder using Browse Network”
To locate the folder manually
A Press [Change] under Path.
B Enter the path where the folder is located.
C Press [OK].
If the format of the entered path is not correct, a message appears. Press [Exit],
and then enter the path again.
Note
❒
Enter the path using this format: “\\ServerName\Share- Name\PathName”.
❒ You can also enter an IPv4 address.
❒ You can enter a path using up to 128 characters.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
