1931
Target Temperature: Hot Roller
These settings set the values for the target temperature of the hot roller, based on the type of
paper used: Plain Paper, Tracing Paper (Trans.), and Film. Each paper type has 5 modes, so
a total of 15 calculations is done:
Type Mode [Range/Default/Step °C]
1
Plain
1
[120 to 220/195/5°C]2 2
3 3
4 4 [120 to 220/185/5°C]
5 5 [120 to 220/175/5°C]
6
Trans.
1 [120 to 220/220/5°C]
7 2
[120 to 220/195/5°C]
8 3
9 4
[120 to 220/165/5°C]
10 5
11
Film
1 [120 to 220/195/5°C]
12 2 [120 to 220/190/5°C]
13 3
[120 to 220/185/5°C]
14 4
15 5 [120 to 220/175/5°C]
016 Plain: Low Temperature Mode [120 to 220/195/5°C]
1932
Target Temperature: Pressure Roller
These settings set the values for the target temperature of the pressure roller, based on the type
of paper used: Plain Paper, Tracing Paper (Trans.), and Film. Each paper type has 5 modes,
so a total of 15 calculations is done. This SP codes sets the start temperature for feedback
pressure control.
SP1932 Settings Table
System Service Mode
105
To Next Page
Loading...
