• If the execution of SP5816-151 has succeeded and embedded RCG-M has connected
to the external line, this SP display is completely blank.
• If embedded RCG-M has connected to an internal line, then the number of the
• connection to the external line is displayed.
• If embedded RCG-M has connected to an external line, a comma is displayed with
• the number. The comma is inserted for a 2 sec. pause.
• The number setting for the external line can be entered manually (including commas).
155
Remove Service: PPP Certification Timeout (SSP)
Sets the length of the timeout for the embedded RCG-M connection to its access point. The
timeout is the time from when the modem sends the ATD to when it receives the result code.
[1 to 65536 / 60 / 1 /step]
156
Dial Up User Name
Use this SP to set a user name for access to remote dial up. Follow these rules when setting
a user name:
• Name length: Up to 32 characters
• Spaces and # allowed but the entire entry must be enclosed by double quotation marks
(").
157
Dial Up Password
Use this SP to set a password for access to remote dial up. Follow these rules when setting
a user name:
• Name length: Up to 32 characters
• Spaces and # allowed but the entire entry must be enclosed by double quotation marks
(").
161
Local Phone Number
Use this SP to set the telephone number of the line where embedded RCG-M is connected.
This number is transmitted to and used by the Call Center to return calls.
Limit: 24 numbers (numbers only)
162
Connection Timing Adjustment Incoming
When the Call Center calls out to an embedded RCG-M modem, it sends a repeating ID
tone (*#1#). This SP sets the time the line remains open to send these ID tones after the
number of the embedded RCG-M modem is dialed up and connected.
[0 to 24 / 1 / 1 /step]
System Service Mode
171
To Next Page
Loading...
