-2397 Incorrect ID2 format
-2398 Incorrect request number format
209
Inst Clear
Releases the machine from its embedded RCG setup.
250
CommLog Print
Prints the communication log.
5821 Remote Service Address Japan Only
1 CSS PI Device Code
Sets the PI device code. After you change this setting, you must turn the machine off and on.
2 RCG IP Address
Sets the IP address of the RCG (Remote Communication Gate) destination for call processing
at the remote service center.
[00000000h to FFFFFFFFh/1]
5824
NVRAM Data Upload GW
Uploads the NVRAM data to an SD card. Push Execute.
Note: When uploading in this SP mode data, the front door must be open.
5825
NVRAM Data Download GW
Downloads data from an SD card to the NVRAM in the machine. After downloading is
completed, remove the card and turn the machine power off and on.
Note: The pages-printed data stored by SP8381 to SP8387 are not downloaded.
5828 Network Setting GW
50
1284 Compatibility (Centro)
Enables and disables bi-directional communication on the parallel connection between
the machine and a computer.
0: Off
1: On
8. Appendix: SP Mode Tables
176
To Next Page
Loading...
