52
ECP (Centro)
Disables and enables the ECP feature (1284 Mode) for data transfer.
0: Disabled
1: Enabled
65
Job Spool Setting
Switches job spooling spooling on and off.
0: No spooling 1: Spooling enabled
66
Job Spool Clear: Start Time
This SP determines whether the job interrupted at power off is resumed at the next power
on. This SP operates only when SP5828 065 is set to 1.
1: Resumes printing spooled jog.
0: Clears spooled job.
69
Job Spool (Protocol)
This SP detemines whether job spooling is enabled or dispabled for each protocol. This is
a 8-bit setting.
0 LPR 4 BMLinks (Japan Only)
1 FTP (Not Used) 5 DIPRINT
2 IPP 6 Reserved (Not Used)
3 SMB 7 Reserved (Not Used)
90
TELNET Operation SettingsTELNET (0:OFF 1:ON)
Disables or enables Telnet operation. If this SP is disabled, the Telnet port is closed.
0: Disable
1: Enable
91
Web Operation Web (0:OFF 1:ON)
Disables or enables the Web operation.
0: Disable
1: Enable
System Service Mode
177
To Next Page
Loading...
