7. Print the configuration page to confirm that the board was attached correctly.
Installing the Bluetooth interface unit
1. Check the contents of the package.
2. Turn the machine off and unplug the power cord.
3. Fully insert the interface unit.
Check that the interface unit is firmly connected to the controller board.
4. Plug in the power cord, and then turn on the machine.
5. Print the configuration page to confirm that the board was attached correctly.
Installing the USB Device Server
The optional USB device server is an interface board that adds an Ethernet port to the machine.
With this option installed, two Ethernet cables can be connected at the same time using the standard port
on the machine and an additional port on the USB device server. You can assign different IP addresses
to each port, so the machine can print jobs from different network segments.
Procedure for installing the USB device server
1. Check the contents of the package.
2. Turn the machine off and unplug the power cord.
Installing Options
37