Supplementary Information
195
5
❖ Booklet/Magazine
• The machine sets the reproduction ratio automatically to meet the paper
size and copies the originals together onto the paper.
• The reproduction ratios you can specify are 25-400%.
• If the calculated ratio is under the minimum ratio, it is automatically ad-
justed to within available range. However, with some ratios, parts of the
image might not be copied.
• If the orientation of originals is different from that of the copy paper, the
machine will automatically rotate the image by 90° to make copies properly.
• You cannot copy with originals different in size and orientation.
• If the number of originals scanned is less than a multiple of 4, the last page
is copied blank.
• In Magazine mode, the copying may take some time after scanning originals.
• When the optional booklet finisher is installed, if you select Saddle Stitch
function in Magazine mode, the machine staples and folds the paper in the
center, then delivers the paper folded.
❖ Image Repeat
• Depending on the paper size, ratio, and orientation, parts of repeated im-
ages may not be copied.
• If you use this function with “Custom Size”, you can copy repeatedly the
image in the area you want by specifying the vertical and horizontal
lengths from the base point. In this case, place your original on the expo-
sure glass.
A Base point
B Horizontal length
C Vertical length
❖ Centering
• Though the original is set to a different orientation from the paper loaded,
the machine will not rotate the image by 90° (Rotate copy).
To Next Page
Loading...
Need help?
General
