Ricoh Printer - Page 398

When DHCP is set to on, the IPv4 address cannot be changed. To change it, set DHCP to
off. Contact your administrator for information about the network configuration.
• Default: 0.0.0.0
• Subnet Mask
You can specify the subnet mask.
When DHCP is set to on, the subnet mask cannot be changed. To change it, set DHCP to
off. Contact your administrator for information about the network configuration.
• Default: 0.0.0.0
• Gateway Address
You can specify the gateway address.
When DHCP is set to on, the gateway address cannot be changed. To change it, set DHCP
to off. Contact your administrator for information about the network configuration.
• Default: 0.0.0.0
IPv6 Settings
• Stateless Sett.
You can enable or disable IPv6.
• Active
• Not Active
• Default: Active
IPsec
This is a security function. For details, contact your administrator.
• Active
• Not Active
• Default: Not Active
Frame Type (NW)
You can select the frame type for NetWare.
• Auto Select
• Ethernet ll
4. Making Printer Settings Using the Control Panel
160
4