1. GUIDELINES, STANDARDS AND CONDITIONS
1.1 Applicable guidelines and standards
The Ridder RB50Eᵖˡᵘˢ tube motor complies with the provisions of the European guidelines that
follow:
Machinery Direcve 2006/42/EC | Low Voltage Direcve 2006/95/EC | EMC Direcve 2004/108/EC
The harmonized standards (or parts of these standards) that follow are applicable:
NEN-EN-ISO 12100:2010 | NEN-EN-IEC 60204-1 |
NEN 82079-1 (62079: 2001) | NEN5509 | ISO 3864-2
Make sure that this product is only put into operaon if the system (in which it will be installed)
complies with the requirements of the applicable standards and guidelines.
1.2 Approved personnel
This product manual contains important informaon for installers about the installaon and
commissioning of a RB50Eᵖˡᵘˢ tube motor. Read this product manual and instrucons rst before the
work starts. Approved mechanical and/or electrical installers, with professional competence, must
do all work safe and responsible.
1.3 Warning about discouraged use
The condions that follow are applicable when the RB50Eᵖˡᵘˢ tube motor is used:
• Do not change the construcon of the RB50Eᵖˡᵘˢ
• It is not permied to use the RB50Eᵖˡᵘˢ to li or move people
• Do not let the torque of the RB50Eᵖˡᵘˢ be more than its maximum
• Do not let the duty cycle of the RB50Eᵖˡᵘˢ be more than its maximum.
Refer to §3.2 for a descripon of the intended use of the RB50Eᵖˡᵘˢ tube motor.
1.4 Warranty provisions
For the warranty period and condions refer to the ‘Condions’ secon on our website at www.
ridder.com, or in the Ridder catalogue.
2. SYMBOLS, WARNINGS AND SAFETY INSTRUCTIONS
2.1 Explanaon of warnings (ISO 3864-2)
This product manual contains ps, notes and warnings of dierent degrees of importance. The list
that follows tells what they mean.
Suggeson to perform an operaon more eecve.
May result in damage or problems if an acon is performed
incorrectly.
Ridder Drive Systems
T +31 (0)341 416 854 F +31 (0)341 416 611 I www.ridder.com
3
To Next Page
Loading...
Need help?
General
