Rigol 2000 Series Programming Guide

2 Command System RIGOL
MSO2000A/DS2000A Programming Guide
2-223
:SOURce<n> Commands (MSO2000A-S/DS2000A-S)
The [:SOURce<n>] commands are used to set the output waveforms and their parameters of the built-in
signal source of the oscilloscope. <n> is the number of the channel (1 or 2) and the operation will be
executed on Source1 by default if [:SOURce<n>] is omitted.
 [:SOURce<n>]:FREQuency[:FIXed]
 [:SOURce<n>]:PHASe[:ADJust]
 [:SOURce<n>]:PHASe:INITiate
 [:SOURce<n>]:FUNCtion[:SHAPe]
 [:SOURce<n>]:FUNCtion:RAMP:SYMMetry
 [:SOURce<n>]:VOLTage[:LEVel][:IMMediate][:AMPLitude]
 [:SOURce<n>]:VOLTage[:LEVel][:IMMediate]:OFFSet
 [:SOURce<n>]:PULSe:DCYCle
 [:SOURce<n>]:MOD[:STATe]
 [:SOURce<n>]:MOD:TYPe
 [:SOURce<n>]:MOD:AM[:DEPTh]
 [:SOURce<n>]:MOD:AM:INTernal:FREQuency
 [:SOURce<n>]:MOD:AM:INTernal:FUNCtion
 [:SOURce<n>]:MOD:FM[:DEVIation]
 [:SOURce<n>]:MOD:FM:INTernal:FREQuency
 [:SOURce<n>]:MOD:FM:INTernal:FUNCtion
 [:SOURce<n>]:APPLy:NOISe
 [:SOURce<n>]:APPLy:PULSe
 [:SOURce<n>]:APPLy:RAMP
 [:SOURce<n>]:APPLy:SINusoid
 [:SOURce<n>]:APPLy:SQUare
 [:SOURce<n>]:APPLy:USER
 [:SOURce<n>]:APPLy?

Rigol 2000 Series Specifications

General

Brand	Rigol
Model	2000 Series
Category	Test Equipment
Language	English