It prompts users to use Arb to finish the output.
6. Restore all instrument settings to factory defaults?
Press Utility System Set to Default; this message will appear.
7. All settings are restored to factory defaults.
Press Utility System Set to Default, all the data and settings will
restore to default.
8. Success to save file.
When succeeded to store the digital waveform; this message will appear.
9. Success to read file. Complete. Digital waveform data of user space
have been changed.
When succeeded to recall the stored digital waveform; this message will
appear.
10. The output of digital logic module is under some limit; please refer to
the user Guide.
When choose “Independ” mode; this message will appear.
11. The output function of analog wave is disabled. The digital logic
output range of speed and phase is extended. Please refer to the user
Guide.
When choose “Depend” mode; this message will appear.
12. Wave file will cover**!
When store a digital waveform in a location where a waveform file already exist,
press Save; this message will appear.
13. Cover the file?
When store a digital waveform in a location where a waveform file already exist,
press End/Store; this message will appear.
14. Delete the file?
Choose a file you want to delete, press Delete; this message will appear.
15. Just displays the trigger mode. It will be changed when burst mode is
used.
Press Arb Edit Digital WF5Trigger; this message will appear.
16. Digital logic module is triggered.
Press Burst Source“Manual”, and press the button Trigger on the front
panel of the instrument; this message will appear.
To Next Page
Loading...