Rigol DG5352 - Chapter 6 Frequency Sweep Output

Chapter 6 Frequency Sweep Output RIGOL
User’s Guide for DG5000
6-1
Chapter 6 Frequency Sweep Output
DG5000 could output Sweep waveform from the single channel or the two channels at
the same time. In Sweep mode, the generator outputs the signal variably from Start
Frequency to End Frequency within the specified Sweep time. The generator supports
sweeping from low to high frequency or from high to low frequency and supports
three sweep types: Linear, Log and Step. Users can set “mark” frequency, Start Hold,
End Hold and Return Time. It also supports internal, external or manual trigger source.
It can generate sweep outputs for Sine, Square, Ramp and arbitrary waveforms
(except Pulse in basic waveform, Noise and DC).
Subjects in this chapter:
 To Enable Frequency Sweep
 Start Frequency and End Frequency
 Center Frequency and Frequency Span
 Sweep Type
 Sweep Time
 Return Time
 Mark Frequency
 Start Hold
 End Hold
 Sweep Trigger Source
 Sweep Trigger Output
w ww. . com
information@itm.com1.800.561.8187