Infinite Burst
In Infinite mode, the cycle number of the waveform is set as an infinite value. The
generator outputs a continuous waveform after receiving trigger signal. Waveform
functions which support Infinite Burst are Sine, Square, Ramp, Pulse and arbitrary
waveforms (except Noise and DC).
When Burst is enabled, press Type to select “Infinite”. In Graphic Mode, an infinite
cycle pulse sketch will appear on the screen.
Infinite Burst could be triggered by “External” or “Manual” source. You can also set
“Start Phase”, “Delay”, “Trigger Input” (external trigger) and “Trigger Output”
(manual trigger).
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
