RIGOL Chapter 3 Arbitrary Waveform Output
User’s Guide for DG5000
3-2
To Enable Arbitrary Waveform
Press Arb to open the operation menu of arbitrary waveform.
1. Freq/Period (Sample)
Set the output “Frequency/Period” of the arbitrary waveform in “Normal” mode.
Set the sample rate when the generator sample data from external memory in
“Play” mode.
2. Ampl/HiLevel
Set the output “Amplitude/High Level” of the arbitrary waveform.
3. Offset/LoLevel
Set the output “Offset/Low Level” of the arbitrary waveform.
4. Phase
Set the “Initial Phase” of the arbitrary waveform.
5. Align Phase
Refer to “Align Phase”.
6. Mode
Select the output mode of the arbitrary waveform to “Normal” or “Play”.
7. Select Wform
Select arbitrary waveform stored in internal or external memories.
8. Create New
Users can define waveform with up to 512k points.
Note: DG5000 can output waveform with up to 128M points. For the waveform of
which the number of points is more than 512k points, users can use the matching
PC software of DG5000 to edit and download waveform to DG5000 for output.
9. Edit Wform
Edit the stored arbitrary waveform.
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
