EasyManuals Logo

Rigol DG5352 User Manual

Rigol DG5352
228 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #137 background imageLoading...
Page #137 background image
Chapter 8 FH Output (Option) RIGOL
User’s Guide for DG5000
8-3
To Enable FH Function
Press Utility CH1 Set (or CH2 Set), use to open the 2/2 menu page,
press FreqHop to enable FH function for CH1 (or CH2). The FH function setting
interface is shown below.
Figure 8-1 FH Function Setting Interface
FH function is invalid when Sweep or Burst function is enabled.
For DG5000, only Sine waveform could be used as the carrier waveform for FH.
Thus, only when the Sine waveform function is enabled, could the FH function be
enabled.
When both Mod (only for AM or ASK) and FH are enabled, the AM carrier
frequency will be varied (it will not be varied when only Mod is used).
w ww. . com
information@itm.com1.800.561.8187

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rigol DG5352 and is the answer not in the manual?

Rigol DG5352 Specifications

General IconGeneral
BrandRigol
ModelDG5352
CategoryInverter
LanguageEnglish

Related product manuals