System Setting
Number Format
You could set the display format of decimal point and thousands separator in number
parameters on the screen. The setting is stored in nonvolatile memory. Press Utility
System Number Format to enter the number format setting interface.
Decimal Point: Could be set as dot “.” or comma “,” and the default is dot “.”.
Thousands separator: Could be set as “On”, “Off” or “Space”. The default is “On”.
Number format has 6 combinations, as shown in the following figure:
Dot + ON (Comma)
Dot + Space
Dot + OFF
Comma + ON (Dot)
Comma + Space
Comma + OFF
Notice: Decimal point and thousands separator cannot be set as dot or comma
simultaneously.
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
