RIGOL Chapter 11 Remote Control
User’s Guide for DG5000
11-2
Remote Control Via USB
1. Connect the devices
Connect the generator (USB Device) with your PC using USB cable.
2. Install the USB drive
As the generator is a USB-TMC device, after you connect the generator to the PC
and turn both on, the PC will display the hardware update wizard dialog box.
Please install the “USB Test and Measurement Device” driver following the
directions of the wizard.
3. Search device resource
Start up Ultra Sigma, the software starts searching the generator resources that
have been automatically connected with pc via USB, or click
to
search manually. The status bar of Ultra Sigma at present is shown like the figure
below:
4. View the resource
The resources that have been searched successfully are shown in the “RIGOL
Online Resource” catalog and the instrument model and USB information are also
displayed as shown in the figure below.
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
