Chapter 7 Burst Output
DG5000 could output burst waveform from the single channel or the two channels at
the same time. In Burst mode, the generator could output waveform with specified
cycle number and could also output “Gated” burst using external gated signal. Sine,
Square, Ramp, Pulse or arbitrary waveform (except Noise or DC) can be used to
generate burst. Noise could only be used for “Gated” burst.
Subjects in this chapter:
To Enable Burst Mode
Burst Type
Burst Phase
Burst Period
Gated Polarity
Burst Delay
Burst Trigger Source
Burst Trigger Output
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
