RIGOL Chapter 9 Store and Recall
User’s Guide for DG5000
9-2
Storage System Overview
DG5000 could store the current instrument state or waveform data in local or external
memory and recall them when needed.
DG5000 provides a local and two external directories. The local directory is “C Disk”
and the external directories are “D Disk” and “E Disk”.
C Disk: with 1G Bytes capacity, provides built-in file management system which
could execute conventional file operations (similar to USB flash device). The
wavetable can be downloaded and store in C Disk through remote command and
the files in USB flash device can also be copied to C Disk.
D Disk: When the USB Host at the front panel detects USB flash device, D disk is
available. Its operation mode is the same as the C Disk’s.
E Disk: When the USB Host at the rear panel detects USB flash device, E disk is
available. Its operation mode is the same as the C Disk’s.
Press the front panel key Store/Recall to enable the Store/Recall function (the key
backlight goes on) and open the Store/Recall interface shown as below.
Figure 9-1 Store/Recall Interface
Notice, DG5000 could identify the file whose file name consists of Chinese or English
Route Directory Display Area File/Folder Display Area
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
